ID.4 2021 ➤
Electrical system - Edition 02.2021
NOTICE
Risk of damage to wiper arm and wiper blade.
– Avoid bending wiper arm and wiper blade.
Removing
– ⇒ Rep. gr. 92; Move wipers to service position.
– Lift wiper arm off the windscreen.
– Release retaining clip in direction of -arrow A-.
– Pull wiper blade -1- in direction of -arrow B- off wiper arm
-2-.
Installing
Install in reverse order of removal, observing the following:
– Insert wiper blade -1- parallel in direction of -arrow- into
wiper arm -2-.
– Push wiper blade -1- into wiper arm -2- until retaining clip is
heard to engage.
– Activate “flick wipe” function to exit the service position.
2.4
Removing and installing wiper arms
Special tools and workshop equipment required
♦ puller -T10369/2-
Removal and installation are described for a left-hand drive
vehicle as an example.
Removing
– ⇒ Rep. gr. 92; Move wipers to service position.
2. Windscreen wiper system
33
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Using a suitable screwdriver, lever off caps -3- from wiper
arms -1-.
– Loosen nuts -2- a few turns.
NOTICE
Risk of damage to wiper arm.
– Always use puller -T10369/2-.
– Fit puller -T10369/2--A- to wiper arms -3-.
– Fit thrust piece -2- to wiper arm shafts.
– Turn bolts -1- clockwise until wiper arms -3- have been
pulled off wiper shafts.
– Remove puller -T10369/2--A- to wiper arms -3-.
– Unscrew nuts -4-.
– Remove wiper arms -3-.
34
Rep. gr.92 - Windscreen wash/wipe system
ID.4 2021 ➤
Electrical system - Edition 02.2021
Installing
Install in reverse order of removal, observing the following:
– Switch on ignition.
– ⇒ Rep. gr. 92; Code wiper motor.
– Actuate “flick wipe” function and allow wiper arms to move to
their end position.
– Fit both wiper arms in approximate park positions on wiper
arm shafts.
– Screw on nuts of wiper arms and tighten them by hand.
– ⇒ Rep. gr. 92; Adjust wiper arms.
Tightening torques
♦ ⇒ Rep. gr. 92; Assembly overview - windscreen wiper sys‐
tem
2.5
Adjusting wiper arms
Procedure
The adjustment procedure is described for a left-hand drive
vehicle as an example.
– Switch on ignition.
– ⇒ Rep. gr. 92; Code wiper motor.
– Actuate “flick wipe” function and allow wiper arms to move to
their end position.
– Switch off ignition.
– Loosen wiper arms ⇒ Rep. gr. 92; Removing and installing
wiper arms.
– Adjust wiper arms.
Driver side
Distance -a- between end of wiper blade and plenum chamber
cover -2- at bottom edge of windscreen must be 12 mm.
– Adjust wiper blade park position by repositioning wiper arm
-1-.
2. Windscreen wiper system
35
2024 VW ID.4 Owner's Manual
