ID.4 2021 ➤
Electrical system - Edition 02.2021
– ⇒ Rep. gr. 94; Removing and installing LED module for day‐
time running light and side light [L176]/[L177].
2.7
Installing repair kit for headlight hous‐
ing
Special tools and workshop equipment required
♦ Torque screwdriver -VAS 6494-
The front left headlight -MX1- and front right headlight -MX2-
will henceforth be referred to as “headlight”.
Note
Defective headlight retaining tabs can be replaced by installing
the repair kit for headlight housing. There is therefore no need
to renew the headlight.
Note
Various headlight housing repair kits are available for the head‐
light ⇒ Electronic parts catalogue (ETKA).
Installing
– Remove headlight with defective retaining tab ⇒ Rep. gr. 94;
Removing and installing headlight.
– Remove remaining parts of defective retaining tab from
headlight housing.
– Fit retaining tab -3- of repair kit to headlight -1-.
– Tighten bolts -2-.
– Install headlight and align it flush to body contour.
– Check headlight settings and adjust headlights if necessary
⇒ Maintenance; Booklet 36.1; Descriptions of work.
Tightening torques
♦ ⇒ o2.2 verview – repair kit for headlight housing”, page 60
2. Headlights
65
ID.4 2021 ➤
Electrical system - Edition 02.2021
2.8
Removing and installing headlight
range control motor [V48]/[V49]
2.8.1
Removing and installing headlight
range control motor [V48]/[V49], ECO
headlights
Special tools and workshop equipment required
♦ ESD workplace -VAS 6613-
♦ Torque screwdriver -V.A.G 1624-
The front left headlight -MX1- and front right headlight -MX2-
will henceforth be referred to as “headlight”.
The left headlight range control motor -V48- and right headlight
range control motor -V49- will henceforth be referred to as “con‐
trol motor”.
Removal and installation are described for the left vehicle side
as an example.
Removing
– Remove headlight ⇒ Rep. gr. 94; Removing and installing
headlight.
NOTICE
Risk of damage to electrical components.
Electrostatic charge may damage electrical components.
– Work on electrical components must always be carried out
at an ESD workplace.
– Place headlight onto ESD workplace -VAS 6613-.
– Turn height adjustment screws at top of headlight as far as
stop towards right.
– Use a hammer to carefully release housing cover -1- along
predetermined break line -2-.
66
Rep. gr.94 - Lights, bulbs, switches - exterior
2024 VW ID.4 Owner's Manual
