ID.4 2021 ➤
Electrical system - Edition 02.2021
8.6
Removing and installing interior aer‐
ial 1 for entry and start system [R138]
The interior aerial 1 for entry and start system -R138- will
henceforth be referred to as “aerial”.
Removing
– Remove centre console insert ⇒ General body repairs, inte‐
rior; Rep. gr. 68; Centre console; Removing and installing
centre console insert.
– Release fastener -2-.
– Remove aerial -1-.
Installing
Install in reverse order of removal.
8.7
Removing and installing luggage com‐
partment aerial for entry and start sys‐
tem [R137]
Special tools and workshop equipment required
♦ removal wedge set -VAS 895 015-
The luggage compartment aerial for entry and start system
-R137- will henceforth be referred to as “aerial”.
Removing
– Remove lock carrier trim ⇒ General body repairs, interior;
Rep. gr. 70; Luggage compartment trims; Removing and
installing lock carrier trim.
– Use removal wedge set -VAS 895 015- to lever aerial -1- in
direction of -arrow A- off pins.
– Disconnect electrical connector -2-.
8. Entry and start authorisation system
103
ID.4 2021 ➤
Electrical system - Edition 02.2021
Installing
Install in reverse order of removal.
8.8
Removing and installing control unit 2
for break-in protection [J1192]/control
unit 3 for break-in protection [J1193]
The control unit 2 for break-in protection -J1192- and control
unit 3 for break-in protection -J1193- will henceforth be referred
to as “control unit for break-in protection”.
Removal and installation are described for the left vehicle side
as an example.
Removing
– Remove front wheel housing liner ⇒ General body repairs,
exterior; Rep. gr. 66; Wheel housing liner; Removing and
installing front wheel housing liner.
– Disconnect electrical connector -3-.
– Release locking lugs -2-.
– Remove control unit for break-in protection -1- in direction of
-arrow-.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Wheel housing
liner; Assembly overview – front wheel housing liner
8.9
Removing and installing control unit 4
for break-in protection [J1194]/control
unit 5 for break-in protection [J1195]
The control unit 4 for break-in protection -J1194- and control
unit 5 for break-in protection -J1195- will henceforth be referred
to as “control unit for break-in protection”.
Removal and installation are described for the left vehicle side
as an example.
104
Rep. gr.94 - Lights, bulbs, switches - exterior
2024 VW ID.4 Owner's Manual
