Table of Contents > Controls > Removing and installing front interior light [WX1]

VW ID.4 Electrical System ➜ Removing and installing front interior light [WX1]

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
– Remove rear lid warning buzzer -H32--2- until electrical con‐  
nector -3- is accessible.  
– Disconnect electrical connector -3-.  
Installing  
Install in reverse order of removal.  
3.16  
Removing and installing front interior  
light [WX1]  
The front interior light -WX1- will henceforth be referred to as  
“front interior light”.  
Removing  
NOTICE  
Risk of damage to component surfaces.  
– Before using a lever, always mask off the components  
installed in visible areas using commercially available ad‐  
hesive tape.  
– Using commercially available plastic wedge, pry out front  
interior light -1- in rear area in direction of -arrow A-.  
– Disconnect electrical connectors.  
– Remove front interior light -1- in direction of -arrow B-.  
Installing  
Install in reverse order of removal, observing the following:  
– The front interior light must be heard to engage.  
3. Controls  
139  
ID.4 2021 ➤  
Electrical system - Edition 02.2021  
3.17  
Removing and installing rear interior  
light/reading light  
3.17.1  
Removing and installing rear interior  
light [WX2]  
The rear interior light -WX2- will henceforth be referred to as  
“rear interior light”.  
Removing  
NOTICE  
Risk of damage to component surfaces.  
– Before using a lever, always mask off the components  
installed in visible areas using commercially available ad‐  
hesive tape.  
– Use commercially available plastic wedge to lever out rear  
interior light -1- in rear area in direction of -arrow-.  
– Remove rear interior light -1- until electrical connector is  
accessible.  
– Disconnect electrical connector.  
– Remove rear interior light -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– The rear interior light must be heard to engage.  
3.17.2  
Removing and installing rear interior  
light [W47]/[W48]  
The rear left interior light -W47- and rear right interior light  
-W48- will henceforth be referred to as “rear interior light”.  
Removal and installation are described for the left vehicle side  
as an example.  
Removing  
– Detach left upper B-pillar trim ⇒ General body repairs, interi‐  
or; Rep. gr. 70; Trims, interior; Assembly overview – B-pillar  
trim.  
– Remove left C-pillar trim ⇒ General body repairs, interior;  
Rep. gr. 70; Trims, interior; Removing and installing C-pillar  
trim.  
140  
Rep. gr.96 - Lights, bulbs, switches - interior  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!