Table of Contents > Entry and start authorisation system > Removing and installing interior aerial 1 for entry and start system [R138]

VW ID.4 Electrical System ➜ Removing and installing interior aerial 1 for entry and start system [R138]

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
8.6  
Removing and installing interior aer‐  
ial 1 for entry and start system [R138]  
The interior aerial 1 for entry and start system -R138- will  
henceforth be referred to as “aerial”.  
Removing  
– Remove centre console insert ⇒ General body repairs, inte‐  
rior; Rep. gr. 68; Centre console; Removing and installing  
centre console insert.  
– Release fastener -2-.  
– Remove aerial -1-.  
Installing  
Install in reverse order of removal.  
8.7  
Removing and installing luggage com‐  
partment aerial for entry and start sys‐  
tem [R137]  
Special tools and workshop equipment required  
♦ removal wedge set -VAS 895 015-  
The luggage compartment aerial for entry and start system  
-R137- will henceforth be referred to as “aerial”.  
Removing  
– Remove lock carrier trim ⇒ General body repairs, interior;  
Rep. gr. 70; Luggage compartment trims; Removing and  
installing lock carrier trim.  
– Use removal wedge set -VAS 895 015- to lever aerial -1- in  
direction of -arrow A- off pins.  
– Disconnect electrical connector -2-.  
8. Entry and start authorisation system  
103  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!