ID.4 2021 ➤
Electrical system - Edition 02.2021
8.2.2
Overview of fitting locations – keyless entry system, right-hand drive vehi‐
cles
The selected repair information is currently being reviewed and
will be available soon.
1 - Front passenger exterior
door handle -EX7-
❑ with contact sensor for
front left exterior door
handle -G605-
❑ ⇒ General body re‐
pairs, exterior; Rep.
gr. 57; Door compo‐
nents; Removing and
installing door handle
2 - Interior aerial 1 for entry
and start authorisation -R138-
❑ ⇒ Rep. gr. 94; Remov‐
ing and installing interi‐
or aerial 1 for entry and
start system [R138]
3 - Left entry and start author‐
isation aerial -R200-
❑ ⇒ a8.5 nd installing
entry and start author‐
isation aerial [R200]/
[R201]”, page 102
4 - Right entry and start au‐
thorisation aerial -R201-
❑ ⇒ a8.5 nd installing
entry and start author‐
isation aerial [R200]/
[R201]”, page 102
5 - Interface for entry and
start system -J965-
❑ ⇒ a8.4 nd installing in‐
terface for entry and
start system [J965]”,
page 100
6 - Driver exterior door handle
-EX6-
❑ With contact sensor for front right exterior door handle -G606-
❑ ⇒ General body repairs, exterior; Rep. gr. 57; Door components; Removing and installing door handle
7 - Luggage compartment aerial for entry and start system -R137-
❑ ⇒ Rep. gr. 94; Removing and installing luggage compartment aerial for entry and start system [R137]
8.3
Assembly overview – control unit for break-in protection
The overview is shown for the left side of vehicle as an exam‐
ple.
8. Entry and start authorisation system
99
ID.4 2021 ➤
Electrical system - Edition 02.2021
1 - Bracket for control
unit 2 for break-in protec‐
tion -J1192-/control unit 3 for
break-in protection -J1193-
2 - Control unit 2 for break-
in protection -J1192-/control
unit 3 for break-in protection
-J1193-
❑ ⇒ a8.8 nd installing
control unit 2 for break-
in protection [J1192]/
control unit 3 for break-
in protection [J1193]”,
page 104
3 - Bolt
❑ qty. 2
❑ 2 Nm
8.4
Removing and installing interface for
entry and start system [J965]
8.4.1
Removing and installing interface for
entry and start system [J965], left-hand
drive vehicles
The interface for entry and start system -J965- will henceforth
be referred to as “interface for entry and start system”.
If the interface for entry and start system unit is renewed, per‐
form the test plan for the renewal of the interface for entry and
start system using ⇒ Vehicle diagnostic tester.
Removing
– Remove driver side footwell cover ⇒ General body repairs,
interior; Rep. gr. 68; Compartments/covers; Removing and
installing driver side footwell cover.
– Disconnect electrical connector -2-.
100
Rep. gr.94 - Lights, bulbs, switches - exterior
2024 VW ID.4 Owner's Manual
