Table of Contents > Windscreen washer system > Assembly overview – windscreen washer system

VW ID.4 Electrical System ➜ Assembly overview – windscreen washer system

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
3
Windscreen washer system  
3.1  
Assembly overview – windscreen washer system  
1 - Right spray jet  
❑ Depending on equip‐  
ment/version  
❑ With right spray jet  
heater element -Z21-  
❑ ⇒ Rep. gr. 92; Remov‐  
ing and installing spray  
jets  
❑ ⇒ Rep. gr. 92; Adjust‐  
ing spray jets  
2 - Left spray jet  
❑ Depending on equip‐  
ment/version  
❑ With left spray jet heat‐  
er element -Z20-  
❑ ⇒ Rep. gr. 92; Remov‐  
ing and installing spray  
jets  
❑ ⇒ Rep. gr. 92; Adjust‐  
ing spray jets  
3 - Electrical connector for  
right spray jet heater element  
-Z21-  
❑ Depending on equip‐  
ment/version  
4 - Electrical connector for left  
spray jet heater element -Z20-  
❑ Depending on equip‐  
ment/version  
5 - Grommet  
6 - Hose for washer fluid  
7 - Windscreen and rear win‐  
dow washer pump -V59-  
❑ ⇒ Rep. gr. 92; Removing and installing washer pump [V59]  
8 - Sealing grommet  
9 - Connection for washer fluid hose for windscreen and rear window washer pump -V59-  
10 - Washer fluid reservoir  
❑ With windscreen washer fluid level sender -G33-  
❑ ⇒ Rep. gr. 92; Removing and installing washer fluid reservoir  
11 - Bolt  
❑ qty. 3  
❑ 8 Nm  
12 - Strainer  
13 - Filler neck sealing cap  
40  
Rep. gr.92 - Windscreen wash/wipe system  
ID.4 2021 ➤  
Electrical system - Edition 02.2021  
3.2  
Removing and installing washer fluid  
reservoir  
The windscreen and rear window washer pump -V59- will  
henceforth be referred to as “windscreen and rear window  
washer pump”.  
Removing  
– Remove front left wheel housing liner ⇒ General body re‐  
pairs, exterior; Rep. gr. 66; Wheel housing liner; Removing  
and installing front wheel housing liner.  
– Place commercially available drip tray under washer fluid  
reservoir.  
– Release locking lug -2-.  
– Pull filler neck -1- upwards out of bracket on lock carrier -3-.  
For a better view, the following work procedure is shown with  
the bumper cover removed.  
NOTICE  
Risk of leakage.  
– The washer fluid reservoir and the filler neck are not inten‐  
ded to be separated from each other.  
– Disconnect electrical connectors -2- and -5-.  
– Release and pull off washer fluid hoses -4- on windscreen  
and rear window washer pump -3-.  
– Pull retainer -1- for wiring harness off washer fluid reservoir.  
– Unscrew bolts -1-.  
3. Windscreen washer system  
41  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!