Table of Contents > Gauges, instruments > Removing and installing horn or dual tone horn [H1]

VW ID.4 Electrical System ➜ Removing and installing horn or dual tone horn [H1]

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
3
Horn  
3.1  
Assembly overview – horn  
1 - Nut  
❑ 11 Nm  
2 - Washer  
3 - Bracket for horn or dual  
tone horn -H1-  
4 - Horn or dual tone horn -  
H1-  
❑ ⇒ Rep. gr. 90; Remov‐  
ing and installing horn  
or dual tone horn [H1]  
5 - Electrical connector  
6 - Bolt  
❑ 6 Nm  
3.2  
Removing and installing horn or dual  
tone horn [H1]  
The horn or dual tone horn -H1- will henceforth be referred to as  
“horn”.  
Removing  
– Remove bumper cover ⇒ General body repairs, exterior;  
Rep. gr. 63; Front bumper; Removing and installing bumper  
cover.  
– Unscrew bolt -3-.  
28  
Rep. gr.90 - Gauges, instruments  
ID.4 2021 ➤  
Electrical system - Edition 02.2021  
– Remove horn -2-.  
– Disconnect electrical connector -1-.  
– Remove horn -2-.  
Installing  
Install in reverse order of removal, observing the following:  
Tightening torques  
♦ ⇒ Rep. gr. 90; Assembly overview – horn  
3. Horn  
29  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!