ID.4 2021 ➤
Driver assist systems - Edition 04.2021
– To remove bracket of lane change assist control unit -1-,
unscrew nut, and detach bracket.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
Component
Specified torque
3.5 Nm
Nut on bracket
3.7
Removing and installing lane change
assist warning lamp in exterior mir‐
ror [K311]/[K312]
Removing
The lane change assist warning lamp in right exterior mirror
-K311- and lane change assist warning lamp in left exterior
mirror -K312- will henceforth be referred to as “warning lamp”.
Removal and installation are described for the left vehicle side
as an example.
– Remove upper mirror cover ⇒ General body repairs, exte‐
rior; Rep. gr. 66; Exterior mirror; Removing and installing
upper mirror cover.
– Push area -3- in direction of -arrow A-, and hold it in that
position.
– Press warning lamp -1- in direction of -arrow B- out of mirror
cover -2-.
Installing
Install in reverse order of removal.
3.8
Removing and installing right/left over‐
head view camera [R244]/[R245]
The left overhead view camera -R244- and right overhead view
camera -R245- will henceforth be referred to as “camera”.
Removal and installation are described for the left vehicle side
as an example.
3. Senders/sensors/control units
13
ID.4 2021 ➤
Driver assist systems - Edition 04.2021
Removing
– Remove lower mirror cover ⇒ General body repairs, exterior;
Rep. gr. 66; Exterior mirror; Removing and installing lower
mirror cover.
– Unscrew bolts -2-.
– Remove bracket -1- with camera -3-.
– Remove camera -3- from bracket -1-.
Installing
Install in reverse order of removal, observing the following:
– ⇒ Rep. gr. 98; Calibrate overhead view camera.
Tightening torques
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Exterior mirror;
Assembly overview – exterior mirror
3.9
Removing and installing control unit for
overhead view camera [J928]
The overhead view camera control unit -J928- will henceforth
be referred to as “overhead view camera control unit”.
•
If the control unit for overhead view camera is renewed,
perform the test plan for renewal of control unit for overhead
view camera using ⇒ Vehicle diagnostic tester.
Removing
– Remove bench seat ⇒ General body repairs, interior; Rep.
gr. 72; Rear seats; Removing and installing bench seat/indi‐
vidual seats.
– Disconnect electrical connectors.
– Release spreader rivets -2-, and remove overhead view
camera control unit -1-.
14
Rep. gr.98 - Assist systems
2024 VW ID.4 Owner's Manual
