Table of Contents > Senders/sensors/control units > Removing and installing front overhead view camera [R243]

VW ID.4 Driver Assist Systems ➜ Removing and installing front overhead view camera [R243]

ID.4 2021 ➤  
Driver assist systems - Edition 04.2021  
Installing  
Install in reverse order of removal, observing the following:  
Tightening torques  
Component  
Specified torque  
2.5 Nm  
Bolts on body  
3.12  
Removing and installing front overhead  
view camera [R243]  
Removing  
The front overhead view camera -R243- will henceforth be re‐  
ferred to as “front overhead view camera”.  
– Remove badge at front ⇒ General body repairs, exterior;  
Rep. gr. 66; Lettering and badges; Removing and installing  
badges at front.  
– Disconnect electrical connector.  
– Push locking devices in direction of -arrow-, and remove  
bracket -2-.  
– Pull front overhead view camera -1- out of front badge.  
Installing  
Install in the reverse order of removal, observing the following:  
Make sure that the front overhead view camera is correctly  
seated.  
The bracket must be heard to engage.  
– ⇒ Rep. gr. 98; Calibrate overhead view camera.  
3. Senders/sensors/control units  
17  
ID.4 2021 ➤  
Driver assist systems - Edition 04.2021  
3.13  
Removing and installing reversing  
camera [R189]  
The reversing camera -R189- will henceforth be referred to as  
“reversing camera”.  
Removing  
– Remove rear lid handle -EX37- ⇒ General body repairs, ex‐  
terior; Rep. gr. 55; Rear lid; Removing and installing rear lid  
handle [EX37].  
– Release locking device -2-, and remove reversing camera  
-1- in direction of -arrow-.  
Installing  
Install in the reverse order of removal, observing the following:  
– ⇒ Rep. gr. 98; Calibrate reversing camera [R189].  
3.14  
Removing and installing rear overhead  
view camera [R246]  
The rear overhead view camera -R246- will henceforth be refer‐  
red to as “rear overhead view camera”.  
Removing  
– Remove rear lid handle -EX37- ⇒ General body repairs, ex‐  
terior; Rep. gr. 55; Rear lid; Removing and installing rear lid  
handle [EX37].  
– Release locking device -2-, and remove rear overhead view  
camera -1- in direction of -arrow-.  
Installing  
Install in the reverse order of removal, observing the following:  
– ⇒ Rep. gr. 98; Calibrate overhead view camera system.  
18  
Rep. gr.98 - Assist systems  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!