ID.4 2021 ➤, ID.5 2021 ➤
Maintenance - Edition 11.2021
4.13
Electric windows: checking positioning
(open and close functions)
Note
The automatic opening and closing features for the electric
windows do not function after disconnecting and reconnecting
the battery. Therefore, before a new vehicle is delivered, the
window regulators must be reactivated. Once the windows have
been reactivated, the battery must not be disconnected again.
CAUTION
After batteries have been disconnected and reconnected the
roll-back function of the electric window regulators is disabled.
Severe pinching injuries could result!
– Reposition window regulator.
Carry out the following procedure to position the electric window
regulators:
Note
The following work description applies to the front left window
regulator. Reactivate the other window automatic functions in
the same manner by operating the respective switch in the
driver door.
– Switch on ignition.
– Close all doors and windows completely.
– Pull up button for window regulator and hold in this position
for at least one second.
– Release button, pull it up again and hold.
The one-touch opening and closing function is now ready for
use.
Note
It is possible to re-establish the position of one or more window
regulators at the same time.
– Switch off ignition.
4.14
Fault memory of all systems: reading
with vehicle diagnostic tester, correct‐
ing possible faults according to repair
guidelines
– Read event memory ⇒ page 12 .
– Repair all faults according to repair guidelines.
Static faults
If one or more static faults are found in the event memory,
we recommend seeking agreement from the customer to rectify
these faults using Guided Fault Finding.
42
4. Descriptions of work
ID.4 2021 ➤, ID.5 2021 ➤
Maintenance - Edition 11.2021
Sporadic faults
If only sporadic faults or messages are stored in the event
memory and the customer has no complaints in conjunction
with the electronic vehicle system, clear event memory.
Note
The vehicle must always be delivered to the customer with
event memory cleared.
4.15
Boots: inspecting
– Check outer and inner boots -arrows- for leaks and damage.
– Ensure clamps -1- are fitted on boots.
4.16
Interior filter: cleaning housing and re‐
newing filter element
Procedure
Note
♦ Use a dust and pollen filter with at least an activated char‐
coal layer, ideally an additional allergy filter layer.
♦ Pollen, soot, fine dust, unpleasant odours, ozone, nitrogen
oxide and allergies can be filtered out effectively in this way.
⇒ Heating, air conditioning; Rep. gr. 87; Front heater and air
conditioning unit; Removing and installing dust and pollen filter.
4.17
High-voltage battery: checking charge
level
Checking charge level of high-voltage battery
Charge level display of high-voltage battery is located in instru‐
ment cluster.
The charge level must be determined for the first time on vehi‐
cle delivery:
4. Descriptions of work
43
2024 VW ID.4 Owner's Manual
